| | |
|
|
|
Re: Hot water to the bath....? |
|---|
| message from Andy P on 10 May 2004 |
Just a thought...
We have an Alpha Ocean 280E boiler. Have you got the hot water
thermostat control (I assume there is one as there is on ours) set
somehwere near maximum? This, I think, should set the maximum water
temperature irrespective of the flow rate. However, on ours wherever it
is set you can still get VERY hot water initially, before the
thermostsat kicks in, and if you turn the hot tap down. With it set to
max the bath tap can be on full and the water too hot to touch.
Andy
|
| troubleinstore replied to Andy P on 10 May 2004 |
Yep, the temperature control is set at max on the boiler.
Turn hot tap on the bath fully on and you get lukewarm water, turn it
down so as you get less flow than the sink tap and you get really hot
water, out of both taps. That was why I was asking in the original post
if the 22mm original pipework that the 15mm hot water pipe from the
boiler fed into would make any difference.
|
|
Archived message: Re: Hot water to the bath....? (UK DIY Home Improvement)
