Re: Cutting across floorboards

message from Jerry Built on 18 May 2004
That's very bad for your tool.

J.B.
 
Ian Stirling replied to Jerry Built on 18 May 2004
Only if you grasp it between your legs.
More seriously, a couple of moments with a dremel will give a nice neat
end, like the original one.
Or even an angle grinder.
 

Archived message: Re: Cutting across floorboards (UK DIY House Decoration)
 
Note: To make this discussion more readable on the page the original messages have been edited to remove most of the references and quoting.