| | |
|
|
|
Re: Hardware error 0502 on lexmark 5150 now dell marketed |
|---|
| message from Navin R. Johnson on 30 May 2004 |
I have fixed this problem by cleaning and re-lubricating the rail that
the print carriage rides on. I used a silicon lubricant but any good
ligh machine oil should work. As for removing the carriage, good luck.
I'm pretty sure you have to disassemble the entire printer to get it
out. And as for the decoder strip, I believe it's the thin mylar ribbon
cable that attaches to the carriage. If it becomes loose or falls out
you'll get the same 0502 error.
Good Luck,
NRJ
|
| Debbie replied to Navin R. Johnson on 31 May 2004 |
Lexmarks
me
the rail that
but any good
carriage, good luck.
printer to get it
thin mylar ribbon
or falls out
Thank you so much for answering my question. I did find
an excellent kb article on Dells support page. The link
is:http://support.dell.com/us/en/kb/document.asp?
dn=1080620#Sectlink It was very easy to follow since it
had pictures. I repositioned the encoder strip and it is
working fine now. Thanks again.
|
| Debbie replied to Navin R. Johnson on 31 May 2004 |
Lexmarks
me
the rail that
but any good
carriage, good luck.
printer to get it
thin mylar ribbon
or falls out
an excellent KB article on Dells site
http://support.dell.com/us/en/kb/document.asp?
dn=1080620#Sectlink That showed pictures, and I was able
to solve the problem. Thanks again!
|
| Phr0 replied to Debbie on 12 Jun 2004 |
i had to clean off the metalstrip as it was GunkeD-up with printer ink.
|
| Phr0 replied to Debbie on 12 Jun 2004 |
sorry the metal strip directly below ink cairrage.
|
|
Archived message: Re: Hardware error 0502 on lexmark 5150 now dell marketed (Microsoft Win XP)
