| | |
|
|
|
How can I change the USB port V1.1 to V2 |
|---|
| message from =?Utf-8?B?cm9iZXJ0bw==?= on 2 Jun 2004 |
I would like to change the version of my USB port, my computer use V1.1 and I´d like change to V2
How can I do this?
Is it only software or a have to buy hardware?
Thanks for help me
|
| Shenan Stanley replied to =?Utf-8?B?cm9iZXJ0bw==?= on 3 Jun 2004 |
If you computer is not equipped with USB 2.0 rated ports, you will have to
purchase a separate card.
|
| Maris V. Lidaka Sr. replied to Shenan Stanley on 03 Jun 2004 |
A follow-up question: I have a D-Link 4-port hub connected to my v1.1 USB
port. If I replace the USB port with a V2 port, will hardware plugged into
the hub run at V2 speed, or do I need to buy a new hub as well?
Maris
Shenan Stanley wrote:
|
| Shenan Stanley replied to Maris V. Lidaka Sr. on 3 Jun 2004 |
If the hub is a 2.0 hub, then you should be able to use it. If not, then
you will need a new hub.
Same goes for cables and other devices. If the cable and/or device is not
2.0, then it won't operate at 2.0 speeds.
|
| JustMee replied to Maris V. Lidaka Sr. on 03 Jun 2004 |
It depends on whether or not your 4 way hub is USB version 2..
USB 2 4 way hubs are readily available, and not very expensive.
JM
On Thu, 03 Jun 2004 18:08:30 GMT, "Maris V. Lidaka Sr."
<nemlidaka@ameritech.net> wrote:
|
| Cari \(MS MVP\) replied to =?Utf-8?B?cm9iZXJ0bw==?= on 2 Jun 2004 |
Hardware.
|
|
Archived message: How can I change the USB port V1.1 to V2 (Microsoft Win XP)
