maintaining a page setup

message from =?Utf-8?B?amx3b29kNDQ=?= on 18 May 2004
It seems that every time that I want to print, I have to reset the page setup.
I am using Access 2000, and I'm thinking that the problem is when I want to print a query.
Standard page setup seems to be all 4 margins of 1 inch each.
I consistently want .5 inch margins, except at the right, where I request 0.
Is there some way of setting the page setup/margins so that I don't have to redo this everytime I want to print, especially whenI reprint a querry within a single session.
I'm not sure, but I think that the report set-up does keep the adjusted page set-up.
Thank you in advance for the advice and help
 
Lynn Trapp replied to =?Utf-8?B?amx3b29kNDQ=?= on 18 May 2004
It's a bug in Access 2000. You need to install the latest Service Pack.
Temporarily you can fix the problem by turning off Name Auto Correct. Go to
Tools > Options > General Tab.
 

Archived message: maintaining a page setup (Microsoft Access Error Message)
 
Note: To make this discussion more readable on the page the original messages have been edited to remove most of the references and quoting.