Page setup reset to default

message from hlam on 09 May 2004
I have a report that is set to 3 columns. It is reset back to its default
each time after the 1st time is run. Does it matter that a query was
executed before the report is run? What is the work around method?

I am running on Access 2000, winxp.

Thanks!
 
Cheryl Fischer replied to hlam on 9 May 2004
http://support.microsoft.com/default.aspx?scid=kb;en-us;240826
ACC2000: Lost Printer Settings When Name AutoCorrect Is Enabled
 

Archived message: Page setup reset to default (Microsoft Access Database)
 
Note: To make this discussion more readable on the page the original messages have been edited to remove most of the references and quoting.